Lenovo BladeCenter HS23 7875 Problem Determination And Service Manual page 134

• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See Chapter 3 "Parts listing" on page 29 to determine which components are consumable, structural, or CRU
parts.
• If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
Error Code Event ID
0x80070100 80070114-2201ffff
0x80070200 80070201-0301ffff
80070201-0302ffff
118
BladeCenter HS23 Blade ServerProblem Determination and Service Guide
Type Error Message
Warning FW/BIOS, switch
(TPM Phy Pres
Set) Warning
Error Processor X,
temperature (CPU
X OverTemp)
critical [Note: X=
1,2]
Action
battery" on page 41
and "Installing the
battery" on page 42).
9. Make sure that the
heat sink is properly
attached to the
microprocessor (see
"Installing a
microprocessor and
heat sink" on page
65).
1. Complete the
administrative tasks
that require the TPM
physical presence
switch to be in the
ON position.
2. Restore the physical
presence switch to
the OFF position.
3. Reboot the system.
4. (Trained technician
only) If the error
continues, replace the
system-board
assembly (see
"Removing the
system-board
assembly" on page
71 and "Installing the
system-board
assembly" on page
71).
1. Check the system
event log for
additional
temperature and fan
information (see
"Event logs" on page
79).
2. Make sure that the
room temperature is
within the operating
specifications (see
"Features and
specifications" on
page 2).