Step 5.
Connect the fan cage assembly power cable to the system board (see "Internal cable routing and
connectors" on page 312).
Replacing the air baffle
Use this information to replace the air baffle.
Note: When you install the second microprocessor, you must also install fan 2 and the air baffle that come
with the second microprocessor upgrade kit.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 35.
To replace the air baffle (two microprocessors installed), complete the following steps.
Step 1.
Slide the air baffle down into the server until the positioning pins fit into the locating holes; then,
press down on the air baffle until the pinch tab clicks into place.
Figure 84. Air baffle installation
Replacing the left-side cover
Use this information to replace the left-side cover.
Make sure that all cables, adapters, and other components are installed and seated correctly and that you
have not left loose tools or parts inside the server. Also, make sure that all internal cables are correctly routed.
Air baffle
Chapter 2
.
Installing optional devices
99