Operation; Setting The Acquisition Unit To Scanner (Onl With Integrated Scanner); Calibrating The Unit - Sirona CEREC MC XL Operating Instructions Manual

6 Operation

Setting the acquisition unit to scanner (onl with integrated scanner)

24
6
Operation
WARNING
Risk of injury on calibration pins/milling instruments
If you reach into the milling chamber (e.g.: when inserting/removing a
ceramic block, changing milling instruments, or inserting/removing a
calibration phantom), you may injure your hand on the calibration pins/
milling instruments.
Be careful not to brush against the calibration pins or milling instruments
with your hand.
Always insert your hand in the milling chamber underneath the calibration
pins and milling instruments.
6.1 Setting the acquisition unit to scanner (onl
with integrated scanner)
✔ In order to use the integrated scanner, the acquisition system first must
Setting the acquisition system to scanner
"Scanner"
be set to .
1. In the menu line, select the command
"Acquisition system"
.
"Configuration"
The
"Scanner"
2. Select and confirm with
The scanner will remain selected until you switch back to
"inEos"
.
6.2

Calibrating the unit

NOTICE
Unit calibrated ex works
The unit is calibrated at the factory. No additional calibration is required
during initial startup. Proceed as described below when performing a
subsequent calibration.
CAUTION
Calibration tools
Use only the supplied calibration tools
Use only the supplied calibration pins and the corresponding calibration
phantom when calibrating the milling unit.
CAUTION
Keeping calibration phantom clean, MC XL
Scanner failure or calibration error
If you do not keep the Calibration body clean, proper calibration cannot be
performed.
✔ Keep the calibration body clean.
➢ Place the calibration phantom in the storage box located in the unit
drawer after each calibration.
Sirona Dental Systems GmbH
Operating Instructions CEREC MC XL
"Settings" "Configuration"
/
window appears.
"OK"
.
D 3439.201.02.11.02 10.2009
/
"3D camera"
or
61 46 885 D 3439