Preparing Optical Scanning (Only With Integrated Scanner); Information On Preparing Models For Implants - Sirona CEREC MC XL Operating Instructions Manual

6 Operation

Preparing optical scanning (only with integrated scanner)

32
6.5 Preparing optical scanning (only with
integrated scanner)
6.5.1

Information on preparing models for implants

NOTICE
Prerequisites
This information applies only under the following conditions:
- Milling units with integrated scanner
- PC with installed inLab 3D software
✔ A master model with manipulation implants is available.
Information on implants
1. Plug a scan body onto each manipulation implant of the master model
until it comes to rest on the shoulder of the implant without any gaps.
2. Prepare a scan model by duplicating each implant situation.
The scan body of the scan model must be facing vertically upward. It
must be visible without undercuts.
3. Glue this model onto the model holder in such a way that it points toward
the clamping shank in the mesial –> direction.
A Clamping shank
Sirona Dental Systems GmbH
Operating Instructions CEREC MC XL
61 46 885 D 3439
D 3439.201.02.11.02 10.2009