Installation And Startup; Transport And Unpacking; Disposal Of Packaging Materials; Installation Site - Sirona CEREC MC XL Operating Instructions Manual

5 Installation and startup

Transport and unpacking

12
5
Installation and startup
5.1 Transport and unpacking
All Sirona products are carefully checked prior to shipment. Please perform
Transport and unpacking
an incoming inspection immediately after delivery.
1 Check the delivery note to ensure that the consignment is complete.
2 Check whether the product shows any visible signs of damage.
NOTICE
Damage during transport
If the product was damaged during transport, please contact your carrying
agent.
If return shipment is required, please use the original packaging for shipment.
Before every transport, the unit must be drained prior to shipment (if it has
been operated). See "Removing water from the unit" [ 46]
Transport without packaging
CAUTION
Damage to the unit or danger of injury during transport without packaging
There is a danger of the unit falling down if it is grasped by its plastic
housing.
➢ The unit should always be carried by two persons.
➢ Do not grasp the unit by its plastic housing.
➢ Always grasp the unit by its chassis next to its feet.
5.2

Disposal of packaging materials

The packaging must be disposed of in compliance with the relevant national
regulations. Please observe the regulations applicable in your country.
5.3

Installation site

WARNING
Install out of the reach of patients!
Do not install or operate the milling unit in the vicinity of the patient (place
it at least 1.5 m away from the patient).
The milling unit requires a level Approx. footprint: 700 x 420 mm (W x D). The
height of the milling unit is:
● with the milling chamber door closed: 425mm
● with the milling chamber door open: 570mm
Install the milling unit in such a way that it is not difficult to operate the main
switch.
Sirona Dental Systems GmbH
Operating Instructions CEREC MC XL
61 46 885 D 3439
D 3439.201.02.11.02 10.2009