Inserting The Milling Chamber Sieve; Installation - Sirona CEREC MC XL Operating Instructions Manual

Sirona Dental Systems GmbH
Operating Instructions CEREC MC XL
61 46 885 D 3439
D 3439.201.02.11.02 10.2009
5.4.4

Inserting the milling chamber sieve

WARNING
Risk of injury on milling instruments
Be careful not to brush against the milling instruments with your hand.
➢ Remove the milling chamber sieve from its packaging and insert it in the
floor of the milling chamber.
5.4.5

Installation

5.4.5.1 Connecting to the PC via LAN
Located on the back side of your unit is anEthernet connection for connecting
the PC to the milling unit. Use a network cable to do this (LAN connection).
Using a network cable
Connect the PC to the LAN port of the unit.
If problems arise when connecting via a network cable, please read the
separate instructions "Operating the MC XL via LAN".
5.4.5.2 Connecting the milling unit to the power supply
NOTICE
Grounded power outlet
The milling unit must be connected to a grounded power outlet.
➢ Connect the milling unit to the power supply with the power cable
included in delivery.
5.4.5.3 Installing the unit
You must connect the unit to the PC before putting it into operation. This is
described in the chapter entitled "Connecting to the PC via LAN" [ 17] or
"Connecting to the PC via WLAN (option)" [ 19].
Unit device search
The unit is connected to the PC via a LAN cable or via WLAN.
5 Installation and startup
Initial startup
17