Start The Milling Process - Sirona CEREC MC XL Operating Instructions Manual

6 Operation

Start the milling process

30
10. Press the catch of the milling chamber door and open the door.
11. Loosen the ball pressure screw.
12. Pull off the model holder.
6.4 Start the milling process
✔ Load or design a restoration (see Operator's Manual, Chapter on
"Design").
1. Start the milling process by clicking the
2. If several milling units are connected, a dialog box will appear. Select the
milling unit you prefer and confirm your choice with
3. Select the milling instruments if necessary. A synoptical table of the
milling instruments and the materials that can be milled using them is
provided in the Chapter "Changing milling instruments" [ 40].
NOTICE
Selecting the milling instruments
Following installation, the inserted combination of milling instruments may
still be unknown to the software. In this case, a dialog box will automatically
open where you then must select the milling instruments currently inserted
in the milling unit:
✔ The dialog box is open.
➢ Select the milling instrument which you have inserted in the left motor
"Left"
mount from the
➢ Select the milling instrument which you have inserted in the right motor
"Right"
mount from the
4. Select the required material from the
appears.
5. Select the required block size.
NOTICE
Error during touch process
Incorrect specification of the block manufacturer or block selection may
lead to failure of the touch process.
6. Confirm your choice by clicking the
The milling unit then moves to the insertion position.
7. Press the catch of the milling chamber door and open the door.
CAUTION
Error message during touch process!
Always be sure to insert the ceramic block that you selected in the
block"
dialog box. Otherwise an error message will be displayed during the
touch process.
8. Place the selected ceramic block in the block clamp.
9. Clamp the ceramic block with the ball pressure screw. Also use the block
clamp tool (see "Using a manual block clamp [ 35]").
10. Close the milling chamber door and confirm the procedure by clicking
"Start" .
The estimated time required for the milling process will then appear in
Sirona Dental Systems GmbH
Operating Instructions CEREC MC XL
"Mill"
icon.
list.
list.
"Select block"
"OK"
button.
D 3439.201.02.11.02 10.2009
"OK"
.
dialog box which then
"Select
61 46 885 D 3439