Sirona CEREC MC XL Operating Instructions Manual page 31

Sirona Dental Systems GmbH
Operating Instructions CEREC MC XL
61 46 885 D 3439
D 3439.201.02.11.02 10.2009
a message window.
NOTICE
Canceling the milling process
You can cancel the milling process at any time by pressing the
button.
11. When the milling process has been completed, open the milling chamber
door.
12. Remove the restoration.
WARNING
Risk of injury on the remainder of the ceramic block
The remaining portion of the ceramic block may have sharp edges (e.g. A)
that could injure you if it is not removed carefully.
Always grasp the remainder of the ceramic block by its metal holder.
13. Loosen the ball pressure screw.
14. Remove the remainder of the ceramic block.
15. Close the milling chamber door.
WARNING
Defective milling results
Do not use defective milling results!
Milling results must be judged by the user (dentist or dental technician) and
must not be used if defects are detected!
NOTICE
Open the milling chamber door
If you have not used the milling unit for a rather long time, we recommend
you should switch it off and then open the milling chamber door so that the
milling chamber can dry out.
6 Operation
Start the milling process
"Stop"
31