Sirona CEREC MC XL Operating Instructions Manual page 18

5 Installation and startup
Initial startup
18
1. In the menu line, select the command
Automatic unit search
"Devices..."
.
"Configure Devices"
The
2. In the window which then opens, select
The software searches for and installs a new device.
"Device Configuration"
The
name here.
3. Confirm your selection with the
The device is installed in the software.
Unit device search
The unit is connected to the PC via a LAN cable or via WLAN.
1. In the menu line, select the command
Manual unit search
"Devices..."
.
The "Configure Devices"
2. In the window which then opens, select
"Add Device"
The window opens.
"Interface" "Network"
3. Select on
4. Enter the IP address of the device in the
NOTICE
IP address
You will find the IP address on your unit's display.
✔ The unit is connected to the power supply.
➢ Switch the unit on, see the chapter on "Switching the unit on and off"
[ 22].
"Config"
➢ Press the button.
The IP address is shown on the display.
5. Confirm your selection with the
"Device Configuration"
The
name here.
6. Confirm your selection with the
The device is installed in the software.
Unit deinstallation
✔ If you no longer require a unit (e.g. a unit is replaced), you can remove it
Uninstalling the unit
from the list.
✔ The unit is operation.
1. In the menu line, select the command
"Devices..."
.
"Configure Devices"
The
2. Highlight the device with a single click.
"Remove"
3. Select the button.
The device is uninstalled.
Sirona Dental Systems GmbH
Operating Instructions CEREC MC XL
"Settings" "Configuration"
/
window opens.
"Add automatically"
window opens. You can assign a device
"Save"
button.
"Settings" "Configuration"
/
window opens.
"Add manually"
.
.
"Host"
field.
"OK"
button.
window opens. You can assign a device
"Save"
button.
"Settings" "Configuration"
/
window opens.
D 3439.201.02.11.02 10.2009
/
.
/
/
61 46 885 D 3439