Starting The Scanning Process (Only With Integrated Scanner) - Sirona CEREC MC XL Operating Instructions Manual

Sirona Dental Systems GmbH
Operating Instructions CEREC MC XL
61 46 885 D 3439
D 3439.201.02.11.02 10.2009

Starting the scanning process (only with integrated scanner)

6.3 Starting the scanning process (only with
integrated scanner)
✔ The acquisition system must be set to Scanner, see "Setting the
Starting the inLab + Cerec scanning process
acquisition system to scanner".
1. Prepare the model holder as described in the chapter "Preparing optical
scanning".
2. Create a new restoration (see Operator's Manual, chapter on "Creating a
new restoration").
3. If several milling units are connected, a dialog box will appear. Select the
milling unit you prefer and confirm your choice with
4. Click the acquisition icon.
"Scanner"
The dialog box opens.
5. The milling unit then moves to the insertion position.
A new dialog box then appears prompting you to insert a model holder
and close the milling chamber door.
6. Press the catch of the milling chamber door and open the door.
WARNING
Sharp edges on scanner!
The scanner on the left milling unit has sharp edges which could cause
personal injury.
Be careful not to brush against the scanner with your hand.
7. Place the model holder in the block clamp.
8. Clamp the model holder with the ball pressure screw. Use the block
clamp tool for this purpose.
The model holder is pressed laterally against the contact surface of
the block clamp and simultaneously pulled in axially. The plate of the
model holder thus rests on the block clamp.
CAUTION
The calibration chamber must remain free of dirt and grime
Make sure that the scanner window and the milling chamber door are kept
free from drops of cooling water, lime and milling dust deposits.
✔ The scanner window or milling chamber door is dirty.
➢ Clean with a soft cloth.
9. Close the milling chamber door and confirm the procedure by clicking the
"Start"
button on your PC.
A two-dimensional image of the scanned model appears in the
background on the monitor.
The expected duration of the scanning process is indicated by a bar
displayed in a message window. This window closes as soon as the
scanning process has been completed.
NOTICE
Aborting the scanning process
You can abort the scanning process at any time by pressing the
button.
6 Operation
"OK"
.
"Stop"
29