Relative Measurements ( Rel); Programming The Capacitance Per Unit Length (1039) - AEMC 1035 User Manual

2.7.7

Relative Measurements ( REL)

Pressing the ΔREL button enables you to store the value measured in the
memory. The measurements that follow are differences compared with
the value in memory. These differences may be positive or negative. The
ΔREL symbol is displayed.
Another press clears the value from the memory and returns the instru-
ment to normal mode.
NOTE: This button can be used at any time except in voltage mode on the
MΩ positions.
2.7.8

Programming the Capacitance per Unit Length (1039)

When the switch is set to nF, a long press on the
programming mode for the capacitance per unit length of the line to be
measured. The value in memory is displayed on the digital threshold dis-
play along with the nF/km symbol.
If no value was programmed previously, the display indicates 50nF/km by
default. It is then possible to modify the value present.
WARNING: During programming, if you change the switch position, you lose
what you have just done. You can quit the programming mode and record the
value by another long press on the
Shop for AEMC products online at:
Digital Analog Megohmmeter Models 1035/1039
ShopAEMC
www.
button activates the
button.
.ca 1.877.766.5412
19