Removal And Reinstallation Of The Front Cover - Mitsubishi Electric MR-J4-TM Instruction Manual

Servo amplifier melservo-j4

Hide thumbs Also See for MR-J4-TM:

Table of Contents

1. FUNCTIONS AND CONFIGURATION

1.7.2 Removal and reinstallation of the front cover

The following shows how to remove and reinstall the front cover of MR-J4-700TM to MR-J4-22KTM and MR-

J4-500TM4 to MR-J4-22KTM4.

The diagram is for MR-J4-700TM.

(1) Removal of the front cover

1) Hold the ends of lower side of the front cover with

3) Pull out the front cover to remove.

Before removing or installing the front cover, turn off the power and wait for 15

minutes or more until the charge lamp turns off. Then, confirm that the voltage

between P+ and N- is safe with a voltage tester and others. Otherwise, an electric

shock may occur. In addition, when confirming whether the charge lamp is off or

not, always confirm it from the front of the servo amplifier.

2) Pull up the cover, supporting at point A).