Table of Contents
Advertisement
6. NORMAL GAIN ADJUSTMENT
(4) Parameter adjustment
[Pr. PB07 Model loop gain]
This parameter determines the response level of the position control loop. Increasing the value improves
track ability to a position command, but a too high value will make overshoot liable to occur at settling.
The droop pulses value is determined by the following expression.
Number of droop pulses [pulse] =
Position command frequency differs depending on the operation mode.
Rotary servo motor and direct drive motor:
Position command frequency
Servo motor speed [r/min]
=
60
Linear servo motor:
Position command frequency = Speed [mm/s] ÷ Encoder resolution (travel distance per pulse)
Position command frequency [pulse/s]
Model loop gain setting
× Encoder resolution (number of pulses per servo motor revolution)
6 - 18
Advertisement
Table of Contents
