■3. Upload operation
Package data written in drive C (Built-in flash memory) can be uploaded to drive A (Built-in SD card), drive B (USB
drive), drive E (USB drive), drive F (USB drive), and drive G (USB drive).
The data storage after uploading can be used for installing the package data on another GOT.
➠
7. INSTALLATION OF BOOTOS AND BASIC SYSTEM APPLICATION
(The following procedure uses drive A as an example.)
Step 1.
Install the data storage used as the uploading destination to the GOT.
For installation/removal procedure of data storages, refer to the following.
➠
GOT2000 Series User's Manual (Hardware)
Step 2.
Touch the upload source drive ([C:Flash Memory]) in [Select drive].
Step 3.
Touch the [Upload] button.
Step 4.
Touch the upload destination drive.
Step 5.
Touch the [Exec.] button to start uploading the package.
Step 6.
When the upload is completed, the dialog box shown below is displayed.
Touch the [OK] button to close the dialog.
4.
5.
6.8 Package Data Management
6
6 - 105