Action For An Incorrect Key Input - Mitsubishi Electric GOT2000 Series User Manual

■2. Displays and key functions
The following describes the displays for the list monitor.
1)
No. Item
1)
List display area
2) Keys
3)
[ ]
*1 The status of contacts and coils is displayed as below.

16.2.18 Action for an incorrect key input

If an incorrect key is input, cancel the input contents.
■1. Operations
(1) Before touching the
Before touching the
(2) After touching the
Write the command again.
➠
16.2.10 Writing commands
Commands finalized by writing and inserting operations are revised (overwritten) with the program writing.
*1
The status of contacts and coils is displayed on the left of device displays.
The same operations as in the READ mode of the FX list editor can be executed.
➠
16.2.8 Displaying sequence programs
Ends the list monitor.
(When the list monitor is executed on the FX list editor screen, the screen is switched to the FX list
editor screen.)
Type of instruction
LD, AND, OR (Contact instruction (Normal open))
LDI, ANI, ORI (Contact instruction (Normal close)) Contact
OUT, SET
RST
MC, STL
LDP, ANDP, ORP, LDF, ANDF, ORF
(Rise or fall contact instruction)
GO key (before reading/writing the input contents)
GO key, touch the CLR key.
key (after reading/writing the input contents)
GO
3)
2)
Display contents
Description
Contact
TC: Coil
Except TC: Contact
TC: Reset
Word device
Except TC and word
device: Contact
Contact
Not monitored
16.2 FX List Editor (GT2105-Q, GT2104-R only)
Status
■ Displayed ■ Not displayed
ON OFF
OFF ON
ON OFF
ON OFF
ON OFF
Value: 0 Value: Except 0
OFF ON
ON OFF
Always ■ not displayed
16 - 39
16