Display; Display Setting - Mitsubishi Electric GOT2000 Series User Manual

2.1

Display

2.1.1

Display setting

Configure display settings.
The items which can be set are shown below. When each item part is touched, the respective setting becomes possible.
Item
Opening screen time
Screen save time
Battery alarm display
Human sensor
*2
Sensor detect level
*2
Sensor detect time
Sensor off delay
*3
Brightness adjustment mode
Brightness adjustment
POWER LED*5
*1
*2
*3
*4
*5
2 - 2
2.1 Display
The title display period at the main unit boot can be set.
The period from the user stops the touch panel operation till the
screen save function starts can be set.
Whether to display system alarm when the voltage of the GOT
internal battery has dropped can be specified.
Screen saver status cancel by human sensor can be set to Effective
or Invalid.
The sensor detect level can be set.
The time corresponding to the [Sensor detect level] is displayed.
(setting is disabled)
When the [Sensor detect level] is changed, the corresponding time is
reflected by touching [OK] button.
The time period from when the human sensor detects no human
movement until the Human Sensor Detection Signal (System Signal
2-1.b5) turns OFF can be set.
The brightness adjustment mode can be set to the standard or low
intensity mode.
The brightness can be adjusted.
Turning on/off the POWER LED can be set.
If setting 0, the title screen is not hidden.
The title screen is always displayed for 4 seconds or longer (which changes depending on the project data contents).
The monitoring time corresponding to the sensor detect level (0 to 10) is as follows.
As the sensor detect level becomes greater, the sensitivity of the human sensor becomes higher.
Sensor detect level
Sensor detect time [s]
For BootOS version D or earlier, the [Standard] mode is specified.
For GT23, the brightness can be adjusted in 16 levels.
The following table shows the correspondences between values set in the utility and the brightness in 16 levels.
Setting value
Brightness adjustment (16
levels)
GT23 does not support.
Description
10 9 8 7
0 0.1 0.2 0.4
1 2 3 4 5 6 7
1 2 3
Setting range
*1
0 to 60 seconds
<At factory shipment: 0 seconds>
*1
0 to 60 minutes
<At factory shipment: 0 minutes>
ON/OFF
<At factory shipment: OFF>
Valid/Invalid
<At factory shipment: Invalid>
0 to 10
<At factory shipment: 10>
0 to 4
<At factory shipment: 0 seconds>
0Min 10Sec to 60Min 0Sec
<At factory shipment: 0Min 10Sec>
Standard/Low
<At factory shipment: standard>
*4
1 to 32
<Default: 32>
Turning on/off
<At factory shipment: turning on>
6 5 4 3
0.8 1 1.5 2
8 ··· 25 26 27 28
4 ··· 13 14
2 1 0
2.5 3 4
29 30 31 32
15 16