Wing Mix - GRAUPNER mz-24 Pro Programming Manual

Wing Mix

Adjusting mixers
In the basic transmitter display, use your finger or the
provided stylus to touch the gear icon labeled "F":
Touch
The display switches to the blue function menu. Touch
the menu item "Wing MIX":
Touch
Phase depending settings
The here mentioned sub-menu offers the possibility
of phase specific settings. Recognizable on the top
left side of the display in green color is displayed the
phase name. As standard is displayed the name of the
phase 1, which is indicated by the name "NORMAL"
or "PHASE 1". As soon as you will have defined one
or many other phases in the "PHASE" menu, you will
be able to switch among those phases. Activate the
corresponding switch or switches if desired to switch
between the phases.
188 Function menu | Airplane models - Airplane mixer
Programming
• ACT column
Within the value field for this column, speci-
fy whether the mixer is generally blocked
or ON .
Once you set this value field to ON, you can turn
the mixer on and off through a control assigned in
the right column "Ctrl/sw".
• SET column
To switch to the related setting menu, touch the
corresponding >> button in the "SET" column:
• "CTL" column
In the value field in the Ctrl/sw column, assign a
control or control switch to the mixer as described
in section "Control and switch assignment".
RUDD >> AILE line
Frequently in aerobatic flight, the behavior of the lon-
gitudinal axis is influenced when the rudder is actu-
ated. This is particularly problematic in "knife edge
flying" in which the only lift is from the fuselage when
the rudder is deflected since the wings are vertical in
this flight position. This can cause a model to rotate
on the longitude axis as if the aileron were actuated.
A correction is necessary along the longitudinal axis
(aileron) within an adjustable range when the rudders
are controlled.
The setting range of ±150 % makes it possible to
appropriately adapt the direction of deflection. This
mixer can optionally be turned on and off by one of
the controls which cannot be independently reset, or
a control switch or even a logical switch, so that the
model can be controlled exclusively using the rudder.
To set the mixer, use a finger or the provided stylus to
touch the middle button in the line "RUDD >> AILE":
(active)
INH
(setting)
The corresponding setting menu opens:
(Control/switch)
(rudder >> aileron)
To enable this, touch the desired value field, such as
the left one:
The color of the field switches from black to blue:
Touch
Touch