GRAUPNER mz-24 Pro Programming Manual page 84

Deleting saved trimming positions
Touch the value field with the trimming value you want
to delete, for example:
Touch the RES button to reset a changed value in the
blue (and hence active) field to the default.
Use the same procedure for other trimming values.
84 Base menu - Trim setting
Digital Trim 1 and 2
Independent from the above described settings of the
trim control 1 ... 4, you can assign the INC/DEC but-
tons "DT1" and "DT2" installed in the mz-24 HoTT
transmitter in the lines "Digital Trim 1" and "Digital
Trim 2" to any desired control channel 5 ... 12 (see
Definition of terms) as the control. Depending on your
setting on CO (global) or (SE (phase) on the top left
side of the display, follows the storage of their trim
options accordingly CO (global) or SE (phase)
The possible trim amount is ±30 %.
Programming
Touch the button in the line of the desired control,
such as "Digital Trim 1":
Touch
The button color changes from black to blue:
Set the desired channel "CH5 ... CH12" with the
–
or button at the right edge, for example:
Touch the RES button to reset a changed value in the
blue (and hence active) field to the default NONE.
Use the same procedure for "Digital Trim 2".
Tip
Real use examples are available in the section
gramming examples".
To optically verify your settings change, by tapping on
the VIEW button at the top right of the display, to
graphically display the options of all trim controls ...
... and the graphic display is assigned to the individual
trim controllers according to the following scheme:
+
"Pro-