GRAUPNER mz-24 Pro Programming Manual page 193

... AND set "ACT" in the sub-menu
the function menu to INH ...
... or a switch assigned in the same line is
switched OFF and in this way in the value field on
the right near "ACT" indicates OFF , ...
... THEN determine the value input in the RATE A
/ B line the grade of deflection of the flap through
the selected control.
To change a previously input value, touch the cor-
responding value field, for example:
"Flap set" of The color of the field switches from black to blue:
Then, in the active (blue) value field, press
crease the current value within a range of ±125%
and – to reduce it, for example:
Use the same procedure with the value for the
downward deflection of the left flap (RATE B) and
for the values of the right flap and for any second
flap pair. Symmetrical and asymmetrical values are
possible.
RES
Touch the
the blue (and hence active) field to the default val-
ue.
Touch
+ to in-
button to reset a changed value in
• "OFFSET" line
In this line, set the phase-specific positions for all
of the flaps in the respective model. This allows
you to set the positions that the individual flaps are
to assume for each phase.
The adjustment range of ±100% allows the flaps
to be moved to the desired position independent
of the rotational direction of the flap servos, for ex-
ample:
Notices
• The available setting options depend on
the number of flaps selected in the basic
settings of the model memory.
• The flap offset of the flaps is set, complete-
ly independently from the used described
in connection with the left "ACT", in the
phase trimming described in the following
"Flap Sett" section.
• The corresponding offset-positions of the
first aileron pair have to be set, according
to the phase, in the "CH5" line and the
eventually required second flap pair has to
be set in the "CH12" line of the
sub-menu:
Function menu | Airplane models - Flaps mixer
"CTL Set"
193