GRAUPNER mz-24 Pro Programming Manual page 51

Select the desired mixer in the actually blue,
then active, value field by tapping on the
or – button which are located on the right
side of the display, for example:
Touch the RES button to reset a changed
value in a blue (active) value field to the de-
fault value.
• "POINT" column
You have selected one or more mixers in the
lines of the "Mixer" column. In the "POINT"
column, specify the support point(s) to be
trimmed.
To select a point, touch the button in the
"POINT" column in the desired line with a
finger or the provided stylus, for example:
Select the desired point L, 1 ... 5 or H in the
+ actually blue, then active, value field by tap-
ping on the + or –
ed on the right side of the display, for ex-
ample:
Touch the RES button to reset a changed
value in a blue (active) value field to the de-
fault value.
Notice
The associated controller does not
have any effect if an undefined point is
selected (in the basic version of the rel-
evant curve mixers, only the points "L" and
"H" are set).
• "PHASE" column
button which are locat-
If you want to, specify in the right "PHASE"
column the programmed phases in which
the governor should be active. In the value
field, in the example, "1 (normal)", the num-
ber refers to the phase number that can be
found in the sub-menu "PHASE".
To select another phase than default Phase1,
touch the button in the "Phase" column in
the desired line with a finger or the provided
stylus, for example:
You can change the current Phase number
in the blue (active) value field by touching
the + or – buttons at the right edge of the
display the desired number of times, for ex-
ample:
Touch the RES button to reset a changed
value in a blue (active) value field to the de-
fault value.
Base menu - Model selection 51