Thr.hold - GRAUPNER mz-24 Pro Programming Manual

THR.HOLD

AR throttle position
In the basic transmitter display, use your finger or the
provided stylus to touch the gear icon labeled "F":
Touch
The display switches to the blue function menu. Touch
the menu item "THR.HOLD":
Touch
AR throttle position
During competition, is expected that gas engines
should be completely turned off. In the training phase,
this is a bit inconvenient since you would have to re-
start the motor after each autorotation landing.
170 Function menu | Helicopter model - THR AR
Therefore, set the value during the training phase in
this display so that the gas motor can be kept idling
during the autorotation phase without the clutch en-
gaging, and so that any electric drive is definitely off.
Tip
With the "Thr.CUT" option in the Base menu, there is an
alternative emergency off function.
• ACT line
To turn this option on and off, touch the value field
of the "ACT" line, for example:
• Ctrl/sw line
In this line, as described in the
assignment section, assign the same switch with
which you switch to the autorotation phase, for ex-
ample:
• SET line
The green arrow to the left of the bar graph indi-
cates the current, influenced by the actual posi-
tion of the Throttle/pitch control stick ao as by the
throttle limit, position of the throttle servo. The red
arrow to the right indicates the currently set auto-
rotation throttle position, as standard -100%.
To change the current autorotation throttle posi-
tion, use the throttle/pitch control stick to move the
green arrow, and possibly the throttle trim, to the
position that the throttle servo is to assume during
autorotation, for example:
Touch the value field of this "SET" line:
Control and switch
The color of the field switches from black to blue:
Touch