Transmitter Output - GRAUPNER mz-24 Pro Programming Manual

Transmitter output

Changing the outputs in the transmitter
In the basic transmitter display, use your finger or the
provided stylus to touch the gear icon labeled "B":
Touch
The display switches to the "green" base menu. Touch
the menu item
"Out.Swap".
Touch
To ensure maximum flexibility in regard to receiver as-
signment, you can freely switch transmitter outputs 1
to 12 in the program of the mz-24 HoTT pro transmit-
ter according to your preference:
With this option, you can distribute the 12 control
channels of the mz-24 HoTT Pro transmitter to trans-
mitter outputs 1 ... 12 as desired.
96 Base menu - Transmitter output
Remember that the display in the
exclusively refers to the control channels that are set
according to the receiver assignment, and that the
outputs are NOT changed.
Programming
Touch the value field in the line of the channel/output
combination to be changed, for example:
Touch
The color of the field switches from black to blue:
Set the desired value with the + or
right edge.
Use the same procedure for the other transmitter out-
puts, for example:
"Servo monitor", Touch the RES
blue (and hence active) field to the default value.
Notice
Any subsequent changes to the settings such as
servo travel settings, dual rate/expo, mixer, etc.,
always have to correspond with the original re-
ceiver assignment.
After you have finished making your settings, touch
BACK
the button at the top left of the display to return
to the menu selection:
Example
In the helicopter program for the mz-24 HoTT Pro
transmitter, the outputs for a pitch servo and the throt-
tle servo have been changed in comparison to previ-
ous Graupner/JR transmitters. The throttle servo is as-
– button at the
signed to transmitter output "6", and the pitch servo is
assigned to output "1". You may wish to keep the pre-
vious configuration. In this case, switch channels 1 and
6 so that (as described above) (control) channel 6 is at
output 1 and vice versa.
Notice
By using the receiver-side channel assignment
function called
grated in the "Telemetry" menu of the mz-24
HoTT Pro transmitter, the 12 control channels of these
transmitters can be distributed as desired within one re-
ceiver as well as to several receivers.
button to reset a changed value in the
"Channel Mapping" which is inte-