GRAUPNER mz-24 Pro Programming Manual page 140

Deleting a support point
In order to delete the set support points 1 to 5, move
the green line with the associated control element
next to the relevant support point. Once the support
point number appears along with the associated val-
ue in the line "POINT" and the point is red (see the
screen-shot below), you can delete it by touching the
ENT button, for example:
Changing the support point value
• X-axis button
Activate this function by touching the button at the
bottom edge of the display.
You can then move an active (red) point to the right
by pressing the + button, or to the left by pressing
the – button: For example, to move point 1 set at
-45% and point 2 set at +45% precisely between
the end position and middle position:
140 Function menu | general - Free mixer
Touch the
tion.
Notices
• If you move the red point horizontally away
from the current control position, the point
Touch
becomes green after a short while, and a
"?" appears in the Point line. This question
mark does not relate to the point which
has been moved but rather indicates that
another point can be set at the current
control position.
• Remember that the percentages in the
"IN"(put) and "OUT"(put) line always refer
to the momentary position of the related
control stick and not to the position of the
point.
• Y-axis button
(X-axis)
Activate this function by touching the button at the
bottom edge of the display.
You can then move an active (red) point to the top
by pressing the
pressing the
X AXIS button to deactivate the func-
(Y-axis)
+
button, or to the bottom by
– button:
Touch the Y AXIS button to deactivate the func-
tion.
Notice
Remember that the percentages in the "IN-
"(put) and "OUT"(put) line always refer to the
momentary position of the control stick and
not to the position of the point.
After you have finished making your settings, touch
the BACK button at the top left of the display to return
to the mixer selection and, if desired, further to the
menu selection: