GRAUPNER mz-24 Pro Programming Manual page 168

For the sake of clarity, make sure to only enter and / or
change an offset value in one of the two options.
Most of the current gyro systems can be adjusted for
a smooth, proportional effect; you can also choose
between two different modes of action by the trans-
mitter.
If the gyro that you are using also has one of these
options, the alternative offset setting enables both the
normal gyro gain and "heading lock mode" as well
as flying with maximum stabilization in normal, slow
fights within this selected mode, and reducing the
gyro gain in fast roundtrips and aerobatics.
You should accordingly take advantage of switching
phases to enter different settings in the "GYRO OFF-
SET" line. Values between -125% and +125% are
possible, for example:
Based on the these phase-specific (offset) settings,
the gyro gain can also be smoothly varied with a con-
trol in the "Gyro" line in the "CTL Set" sub-menu, .
168 Function menu | Helicopter model - Gyro/Gover
"Governor ACT" line
In the above figure, this option is normally OFF , which
means that the control channel 8 can be normally
used without restriction.
If you have or wish to connect a governor to output
8 to automatically maintain the rotor speed, touch the
value field of this line with a finger or the provided
ON
stylus to turn it ...
... and vice versa.
"Governor RATE" line
After you have activated the option "Governor at CH8"
by switching to ON in the previous line, you can set
the rotor speed to be maintained by your governor in
this line by changing the percentage.
The adjustment range is 0 to 100%.
Touch the value field of this line:
Touch
The color of the field switches from black to blue:
You can change the current value in the blue (active)
value field by touching the + or –
edge of the display, for example:
Touch the RES button to reset a changed value in a
blue (active) value field to the default value.
After making your settings, leave this menu and go to
"Menu selection" by touching the BACK
top left of the display.
buttons at the right
button at the