Mini-Usb Connection - GRAUPNER mz-24 Pro Programming Manual

Tip
In order to be aware of important software updates, you
should therefore register at https://www.graupner.de/
de/service/produktregistrierung.aspx. This will allow you
to automatically receive updates by e-mail.
Importing and exporting model memories
To exchange data between transmitters of the same
make or to backup data, model memories can be cop-
ied to the inserted memory card, or from the memory
card to the transmitter. More information can be found
in the section "Import from SD card" or
card"..
Notices
• Some of the special characters used in mod-
el names cannot be transferred to FAT and
FAT32 file systems due to the specific restric-
tions of these file systems used by the mem-
ory card and are therefore replaced by a tilde
(~) during the copying process.
• The model memories of the mz-24 and mz-
24 Pro transmitters are in principle compati-
ble, BUT:
In order to import from an SD card in another
a transmitter type, the desired model memory
must be copied or moved to a corresponding
directory on a desktop or laptop. For example
from \\Models\mz-24 to \\Models\mz-24pro
or vice versa.
More information on "import from SD card"
After importing from an SD card, you always
need to check each and every model func-
tion and in particular adapt the control and
switch functions to the respective transmitter.
12 Connection on the back side

Mini-USB connection

Located under the rear cover of the mz-24 HoTT Pro
transmitter, there is a connection socket for software
updates as well as the date and time setting from a
desktop or laptop with one of the Windows operating
systems (XP, Vista, 7 ... 10):
"Export to SD
The USB cable that comes with the set is plugged into
this socket. The procedure for obtaining software up-
dates through a computer is described in the software
package instructions.
The software that the computer needs as well as the
appropriate USB driver can be found on the download
page at www.graupner.de
After the required driver and software are installed, the
transmitter can be updated as needed using this con-
nection, or the date and time can be set.
for the respective product.