GRAUPNER mz-24 Pro Programming Manual page 139

... and assign a switch or control switch as described
in section Control and switch assignment:
After you have finished making your settings, touch
the BACK button at the top left of the display to return
to the mixer selection:
Setting curve mixers 6 ... 8
These three curve mixers make it possible to define
extremely nonlinear mixer guide lines with up to five
freely positionable points between the two endpoints
"L" (low = -100% control travel) and "H" (high =
+100% control travel) along the control travel.
Programming details
The control curve is defined by up to 7 points, so-
called support points. In the default settings of the
program, 2 support points are already defined, the
endpoints "L" and "H".
Notice
The following examples are only for demonstra-
tion purposes and do not represent a realistic
mixer guide line.
Setting support points
A green vertical line (normally hidden) is moved syn-
chronously in the graphic between the two endpoints
with the mixer input control, here the control function
8 of the side proportional rotary control SL1.
To show this line, touch the ST OFF
bottom left:
Touch
After this value field is switched to
vertical line representing the momentary control posi-
tion appears, and the control position is also numeri-
cally displayed in the "IN(put)"line.
In the following example, the control at input 8 is at
-45% of the control travel. The output signal remains
0% since a value has not been entered:
The intersection of this line with the mixer curve is
identified as "OUT(put)" and can be varied at the sup-
port points within a range of ± 125% (see below). This
resulting control signal affects the mixer output.
Between the two endpoints "L" and "H", up to five
additional support points can be set, and the distance
between neighboring support points may not be less
than approximately 25%.
Move the green line through the related control. As
soon as you tap on ENT , right on the bottom ...
button at the
... a red dot appears at the interface between the
two lines. At the same time, the "?" is replaced with
a point number, and the value field to the right shows
ST ON , the green
the current output value:
As described below, the set point can be moved hor-
izontally with the
approximately ± 90%, and vertically with the
function within a range of ±125%.
Notice
If the relevant control is not set precisely at the
support point, it should be remembered that the
percentages of the "input" and "output" lines al-
ways refer to the momentary control position.
Use the same procedure for the other support points.
The sequence in which the up to five points between
the end points "L" and "H" are generated does not
matter since the support points are automatically re-
numbered sequentially from left to right after one sup-
port point is set or deleted.
Function menu | general - Free mixer
Touch
X-axis function within a range of
Y-axis
139