GRAUPNER mz-24 Pro Programming Manual page 87

puts made in the "Transmitter output" sub-
menu, or in the "Receiver output " sub-menu
setting" sub-menu.
of the "Transmitter
• The count of the channels displayed in this
menu refers to the maximum control channels
available in the transmitter. The number of us-
able channels depends on the type of receiver
as well as the number of connected servos
and may therefore be significantly less.
• Use this display while programming the model
since you can immediately check all your set-
tings on the transmitter. This does not relieve
you of the responsibility, however, of carefully
testing all the program steps on the model be-
fore first use to make sure there are no errors.
Servo test
Notice
Only start a servo test in a model memory creat-
ed for this purpose without any mixer. Otherwise,
unforeseeable servo deflections will occur.
To activate the servo test function, use a finger or the
provided stylus to touch the TEST field at the top right:
Additional buttons appear at the right edge of the dis-
play:
To change the default cycle time of 0.5 seconds,
touch the corresponding value field. The color of the
field switches from black to blue:
In the blue value field, the time for a movement cy-
cle can be changed at 0.5 s steps between 0.5 and a
maximum of 5.0 seconds with the
the right edge:
Touch
Touch the RES
active field to the default of 0.5 seconds.
Start the servo test by touching the
the bottom right:
... whereupon a safety query appears in the display:
+ or – button at
button to reset a changed value in the
START button at
Touch
Base menu - Servo monitor 87