GRAUPNER mz-24 Pro Programming Manual page 45

To transfer the model name into the model memory,
touch the red button = [ENTER] at the bottom right:
Touch
WIZ.
Touch the button at the top left to go to the next
option:
Touch
"Model type"
Since at this juncture we want to program a "helicop-
ter model", touch the Heli button:
Touch
After selecting the basic model type, the following ap-
pears in the display...
"Swashplate type"
... in which you can specify the number of swashplate
servos by touching the corresponding selection field:
• "1 Servo"
You are using a flybar system, or the swashplate is
tilted by a roll and nick servo. One separate servo
is used for the pitch control.
(Since helicopter models with only one pitch servo
that have three swashplate servos for pitch, nick
and roll also operate without a mix of functions in
the transmitter as is usually the case with flybar
systems, the menu item "Swash", page , normally
does not appear on the multifunction menu.)
• "2 Servo"
The swashplate is shifted axially for the pitch con-
trol by means of two roll servos; the nick control
is decoupled by means of a mechanical compen-
sation rocker.
• "3Sv (2Roll)"
Symmetrical three-point control of the swash-
plate by means of three articulations points offset
by 120°, by means of which one nick servo (front
or rear) and two roll servos (to the left and right
side) are connected. All of the three servos of the
swashplate shift axially for pitch control.
• "3Sv (140)"
Asymmetrical three-point control of the swash-
plate by means of three articulations points offset,
by means of which one nick servo (rear) and two
roll servos (to the left side and right front) are con-
nected. All of the three servos of the swashplate
shift axially for pitch control.
Base menu - Model selection 45