Fresh Food Doors - GEAppliances CFE28TSH Technical Service Manual

After installation of the freezer drawer front, check
for uniform gaps (top and bottom of right and left
hand side). The gap should be 0.6 inches.
The 6 mounting screws (three on each
side) are NOT interchangeable with the center or top
hinge screws.
1. Loosen the six 3/8 in. hex head bolts (three on
each side) that attach the drawer front to the
slide assemblies.
2. Adjust the 3/32 in. Allen set screw clockwise if
the gap at the top is too big.
3. Adjust the set screw counterclockwise if the gap
at the bottom is too big.
4. Tighten the 3 screws on each side (right and left).
5. Recheck the gaps and repeat steps 1 to 4, if
required.
The procedure to remove the right and left fresh
food doors is similar. There are no wires or water
lines on the right side door.
To prevent damage or injury, securely tape
the door shut with masking tape or have a second
person support the door.
1. Remove the hinge cover (see Hinge Cover
section).
2. Disconnect both electrical connectors at the top
cover.
3. Remove the 1/4 in. hex head screw to
disconnect the ground wire from the hinge.
4. Remove the 1/4 in. hex head screw to remove
the strain relief from the hinge.
– 15 –
(Continued next page)