GEAppliances CFE28TSH Technical Service Manual page 32

1. Wake the screen.
2. Simultaneously press and hold the Water,
Cubed, and Precise Fill buttons for 5 seconds.
The display on the upper right should show the
status of the sensors.
Place a cup in the recess, the display will then show
Cup Presence, Lip Detect, Level Trac wait, and then
go back to sleep when the container is removed.
If there is a lower sensor failure, the display will not
detect the container.
If the display cycles through these test messages,
the sensors are OK. If the Auto Fill display quickly
displays between Cup Presence and Lip Detect, the
upper sensors have failed and need to be replaced.
Press the Auto Fill button to begin dispensing water
and the LCD will display the amount.
1. Enter service mode by simultaneously pressing
Water, Cubed, and Crushed buttons for 5
seconds.
2. Select Yes.
3. Once in service mode, use code 00-16 to reboot
the refrigerator (see the
section in this Service Guide).
Functions
Service Diagnostic
– 32 –
Sleep
Cup Presence
Lip Detect
Level Trac wait
(Continued next page)