Fresh Food Evaporator Cover - GEAppliances CFE28TSH Technical Service Manual

4. Pull the thermistor out from the four tabs in the
cover.
Tab (1 of 4)
5. Cut the thermistor wiring as close to the
thermistor as possible.
6. Strip the outer insulation from the thermistor
case harness back 1 inch. Strip the two internal
wires back 3/16 inch for splicing.
7. Prepare the replacement thermistor by cutting
the wiring 4 inches back from the thermistor
and strip the wires back 3/16 inch.
8. Using two bell connectors (
WR01X10466), splice the wiring. After the splices
silicone grease (
Silicone Grease
9. Snap the thermistor into the grille and replace
the foil shunt ( : WR01X11066) inside the
cover. Place excess wiring into the thermistor
pocket, then snap the grille back into the liner,
taking note of the alignment pin.
Thermistor
:
: WR97X163).
The fresh food evaporator cover is held to the back
screws.
1. Remove the two fruit and vegetable drawers,
climate control shelf, and deli pan that are in
front of the evaporator cover.
2. Remove the deli pan covers and deli pan slides
(see Deli Pan Assembly section).
3. Press down and remove the fan harness cover.
Press Here
4.
the top of the evaporator cover.
5. Tilt the top of the evaporator cover out and
disconnect the deli pan fan and damper wire
harness. Remove the cover.
Fan and Damper Wire Harness
– 69 –
Fan Harness Cover
Evaporator Cover