Fresh Food Fan - GEAppliances CFE28TSH Technical Service Manual

The fresh food fan is inserted in a recess in the
bottom of the fresh food air duct.
The fresh food fan will operate at three speeds with
RPM feedback to the control. The speed range of the
fresh food fan is 1500 RPM to 4100 RPM.
To replace the fresh food fan, the fresh food
evaporator cover must be removed.
The fan connector can be accessed for
multi-meter checks by removing the right vegetable
bin and the fan harness cover from the evaporator
cover.
1. Remove the fresh food evaporator cover (see
Fresh Food Evaporator Cover, follow steps 1
through 5).
2. Disconnect the fresh food fan wire harness.
3. Pull the fresh food fan out from the air duct.

Fresh Food Fan

When reinstalling the fan make sure the tag on the
fan is facing up and the harness exits the housing at
the to right as shown.
The freezer drawer utilizes two closure mechanisms
that automatically pull the drawer shut when it is
within 1 inch of the closed position. The mechanisms
are built into the two freezer drawer slide assemblies
and are not replaceable as a separate part.
Fan Harness Cover
The freezer drawer is inserted into alignment
slots (one on each side), and attached to the slide
assemblies with 6 bolts (three on each side).
1. Remove the freezer drawer front (see Freezer
2. Remove the plastic clip from the crossbar.
Disconnect
3. Pull the crossbar to the right, then remove it
– 71 –
Freezer Drawer Closure Mechanism
Drawer Front section).
Plastic Clip
Crossbar
from the right side drawer gear.
(Continued next page)