Way Valve Coil - GEAppliances CFE28TSH Technical Service Manual

6. Remove the 1/4 in. screw to dismount the
water valve from right rear of the machine
compartment (as viewed from the rear) then
move to the side. Water can remain connected.
7. Remove the 1/4 in. screw from the right side of
the condenser (as viewed from the rear).
8. Slide the condenser to the right to disengage
from the shroud.
9. Carefully pull discharge tube from the notch at
the bottom of shroud.
10. Pull shroud outward and over the discharge
tube to disengage the 4 tabs at the bottom to
remove from the base pan.
The 3-way valve coil is attached to the top of the
3-way valve.
1. Remove the machine compartment cover (see
Machine Compartment Cover section).
2. Remove the 1/4 in. hex head screw that
attaches the 3-way valve bracket and rubber
grommet to the refrigerator.
3. Carefully reposition the 3-way valve and drier
to gain better access to the condenser fan and
valve wire harnesses.
4. Disconnect the wire harness attached to the
back of the 3-way valve coil.
5. Disconnect the fan and valve wire harness from
the cabinet.
6.
pry out the tab and lift the 3-way coil from the
valve assembly.
1/4" Screw
– 78 –
Rubber Grommet
(behind bracket)
Disconnect