Deli Pan Assembly - GEAppliances CFE28TSH Technical Service Manual

The deli pan assembly on most models consists of
the deli pan, pan cover, pan slide assemblies, circuit
board, thermistor and fan assembly.
The deli pan circuit board sends the customer
setting to the main board to control the pan
temperatures based on the deli thermistor value.
Temperature is controlled by varying fan speeds as
needed.
The consumer presses the select button (tactile
switch) to scroll thru the settings.
LEDs on the control above the selection will light the
selected mode. Colored LEDs will also light the pan
area for 3 seconds then turn to white.
The deli pan circuit board is located inside the deli
pan front cover.
1. Remove the vegetable bins, vegetable bins
cover, and deli pan.
2. Remove the two 1/4 in. hex head screws from
the top of the deli pan covers.
3. Lift the front deli pan cover, disconnect the wire
harness, and place the cover on a protective
surface. On 22 cu. ft. models, the connector is
on the right.
In the following steps, the shield over the
circuit board is attached to the cover with 7 tabs.
– 65 –
Disconnect
(Continued next page)