Ambient Thermistor - GEAppliances CFE28TSH Technical Service Manual

The ambient thermistor is located inside the center
hinge cover on the top of the cabinet The thermistor
is used to set the duty time of the sweat heaters
and adjust the cooling system based on room
temperature.
1. Place the hinge cover in the service position (see
Hinge Cover section).
2. Pull the thermistor out from the retaining clips.
Clips
3. Place the replacement thermistor next to the
original thermistor.
4. Cut the wiring at a location that will match the
original length when the replacement thermistor
is spliced to it.
5. Use plastic bell connectors (
WR01X10466). Fill each connector with silicone
grease then splice a new thermistor into the
harness, as shown in the illustration below.
Silicone Grease
The Wi-Fi board is located under the center part
of the fresh food hinge cover. It is mounted to the
RJ45/Humidity board and is only available as a
complete board assembly.
powered up.
Thermistor
A wire harness is connected to the board. The board
is attached to the hinge cover with two Phillips-head
screw.
Note the location of the mini-manual.
:
The Wi-Fi board works in conjunction with the GE
GE Kitchen App, the consumer can monitor and
adjust freezer and refrigerator temperatures, start
water heating for all hot water selections, schedule
water heating days and times and update software.
The app can be used with multiple appliances
Using hot water selections from the UI will cancel
App selections.
Scheduled heating cycles will maintain the water
temperature for 15 minutes.
– 61 –
RJ45 Connector
Power LED
Humidity Sensor
Wire Harness
Wi-Fi Module
Mini-manual