GEAppliances CFE28TSH Technical Service Manual page 66

4. Simultaneously press each of the three bottom
tabs while lifting the bottom of the circuit board
shield.
5. Slide the circuit board shield out from the four
top tabs.
6. Remove the two T-15 Torx screws from the
circuit board.
7. Carefully press each of the four tabs and remove
the circuit board from the deli pan cover.
Tab
Tab
8. Disconnect the circuit board wire harness.
1. Unplug the refrigerator.
2. Access the deli pan thermistor (see
3. Turn the circuit board shield over to access the
thermistor.
4. Pull the thermistor out from the four tabs in the
circuit board shield.
5. Place the replacement thermistor next to the
original thermistor.
6. Cut the wiring at a location that will match the
original length when the replacement thermistor
is spliced to it.
7. Use plastic bell connectors (
Tab
WR01X10466). Fill each connector with silicone
grease, then splice a new thermistor into the
harness, as shown in the illustration.
Tab
– 66 –
section, follow steps 1 through 6).
Deli Pan Thermistor
Tab (1 of 4)
:
Silicone Grease
(Continued next page)