Freezer Drawer, Bin, And Basket - GEAppliances CFE28TSH Technical Service Manual

The freezer drawer front is inserted into alignment
slots (one on each side) and attached to the slide
assemblies with 6 bolts (three on each side).
1. Remove the freezer drawer, bin, and basket (see
2. Remove six 3/8 in. hex head bolts (three on each
side) that attach the drawer front to the slide
assemblies.
3. Lift the drawer front from the slide assemblies.
4. Place the drawer front on a protected surface.
section).
L
I
F
T
– 14 –
• When installing the freezer drawer front, make
sure the drawer alignment tabs are placed
inside the alignment slots before installing the
six 3/8 in. hex head bolts.
• An adjustment knob is provided on each side
of the freezer drawer front to change the
horizontal drawer position using a T-27 driver.
0 - Initial position
1 - Lift by 0.050"
-1 - Lower by 0.050"
-2 - Lower by 0.100
-3 - Lower by 0.150"
Knob
Slot
Set Screw
Tab
(Continued next page)