Dispenser Assembly - GEAppliances CFE28TSH Technical Service Manual

The dispenser assembly incorporates the user
interface (UI) used for temperature control and
features and houses the dispenser LED lights and
ultrasonic sensors.
1. Pull the bottom of the display assembly out,
then lower the display assembly from the
dispenser recess.
Display Assembly
2. Disconnect the left side wire harnesses and lift
and pivot open the metal shield.
Disconnect
Disconnect
Metal Shield
3. Disconnect the speaker wire, two upper
ultrasonic sensors, and the lower ultrasonic
harnesses.
In the following step, the shield wire uses a
releasing lock tab.
ELECTRICAL TERMINAL
RELEASE/LOCKING TAB
4. Disconnect the shield wire from the metal shield.
5. Remove the six T-15 Torx screws that attach the
display board to the display cover bracket.
6.
7. Disconnect the duct door motor wire harness
and remove the motor wiring from the wire
retainers.
8. Push up on both the right and left retainers and
pull the funnel out from the dispenser recess.
: The funnel on GE/Adora models is attached
to the dispenser recess with two 1/4 in. hex head
screws.
Disconnect
– 82 –
Disconnect
Disconnect
Retainer
Wire Retainers
Fill Tube
Funnel
(Continued next page)
Shield
Wire