GEAppliances CFE28TSH Technical Service Manual page 83

Before performing the following step, take
notice of the position of the duct door return spring.
9.
duct door motor out from the motor bracket.
Return Spring
10. Move the motor, return spring, and duct door as
an assembly to the right, then remove the duct
door from the door bracket at the left.
Door Bracket
•
•
•
•
Duct Door Motor
1. Remove the funnel (see
Motor Bracket
2. Disconnect the actuator switch wire harness.
3.
– 83 –
The paddle switch is a 2-position switch with
three wires. It has a normally open and a
normally closed contact.
Both the door board and user interface board
(UI) look for a change of state of both contacts
when the paddle is depressed before the
selected function is activated.
The door board monitors one of the contacts
and the user interface board (UI) monitors the
other contact.
The paddle and switch are attached to the
dispenser recess with two top pins and two
bottom tabs located inside.
follow steps 1 through
9).
Disconnect
inward and disengage each top pin from the
dispenser recess and then pull the paddle up.
(Continued next page)