GEAppliances CFE28TSH Technical Service Manual page 13

The handle design varies based on models, however,
the installation is the same.
Loosen the set screws with an 1/8 in. Allen wrench
and remove the handle.
If the handle mounting fasteners need to be
adjusted or removed, use a 1/4 in. Allen wrench.
M
OUNTING
F
ASTENERS
M
OUNTING
F
ASTENERS
:
– 13 –
1. Open the freezer drawer, then lift and remove
the freezer drawer.
2. Remove the freezer drawer bin by pushing the
plastic tab on either the left or right side to
release the bin hinge pin.
3. Remove freezer basket by lifting up the rear of
the basket and moving basket rearward until
the front of the basket can be rotated upward
and out.