Isolation Water Valve - GEAppliances CFE28TSH Technical Service Manual

house water pressure.
The isolation valve is operated by the main control
board. The valve coil has an approximate resistance
value of 390 ohms.
The isolation water valve is located in the machine
compartment and to the right of the condenser.
1. Remove the machine compartment cover (see
Machine Compartment Cover).
2.
then remove the 1/2 in. nut that attaches the
water supply line to the isolation water valve.
3. Remove the 1/4 in. hex head screw and valve
from the cabinet.
4. Disconnect the water valve wire harness.
5. Remove the plastic lock clip from the coupling.
6. Carefully push the collar in while pulling the
water line out from the valve.
Disconnect
Lock Clip
The water valve is located inside the left side
refrigerator door. Models with Precise Fill and Auto
of the water valve. The water valve supplies water
to the icemaker and dispenser. Each coil on the
water valve has an approximate resistance value
of 400 ohms. It is necessary to remove the access
procedure to remove the water valve on GE/Adora
models is similar.
1. Remove the tank inlet tubing from the water
valve (see Water Tank, step 1 through 3).
2.
3. Carefully push the collar in while pulling the
water line out from the coupling.
Lock clips must be reinstalled to prevent
leaks. After the water line is removed from the
connector, the lock clip can be reinstalled on the
connector. The water line can then be inserted with
the clip in place.
1/2 in.nut
4. Disconnect the valve wire harness.
5. Remove the two 5/16 in. hex head screws that
attach the valve to the refrigerator.
Water Valve
– 99 –
Disconnect
Flowmeter
Collar
Clip
(Continued next page)