GEAppliances CFE28TSH Technical Service Manual page 16

5. Push the collar in while pulling the door inlet
tube out from the connector located at the rear
of the cabinet. Remove the tube from retainer.
Retainer
6. Pull the water line through the case conduit
from the top to free the line for door removal.
7. Remove the 3/8 in. hex head screws that secure
the top hinge to the cabinet.
8. Lift the hinge straight up to free the hinge pin
from the recess in the top of the door.
9. Remove the anti-kink spring from the water
tube.
Water Line
3/8" Hinge Bolts
Tube Spring
Hinge Pin
– 16 –
: In the following step, to prevent damage to
the door and electronics, carefully place the door in
a protected location.
The lower door hinge pin and hinge are keyed
and must be matched correctly for the door to self-
close properly. For proper installation later, please
follow the directions carefully.
10. Remove tape, and keeping the door as vertical
as possible, open the door to 90 degrees+, then
lift straight up from the bottom hinge.
L
I
F
T
(Continued next page)