GEAppliances CFE28TSH Technical Service Manual page 72

The procedure to remove both drawer slide
assemblies is similar.
4. Remove the three T-20 Torx screws from the
drawer bracket.
Drawer Bracket
5. Lift the drawer bracket from the slide assembly
6. Pull the drawer slide out to the stop position
7. Remove the two T-20 Torx screws from the
drawer slide.
8. Press in the lock tab and pull the drawer slide
straight out from the slide holder.
Drawer Slide
9. Remove the four recessed 1/4 in. hex head
screws from the slide holder.
10. Pull the slide holder out from the freezer wall.
Slide Holder
Lock Tab
– 72 –
The freezer evaporator cover is held to the back wall
of the freezer with two 1/4-in. hex-head screws.
f
1. Remove the freezer fan cover. (See
follow steps 2 and 3.)
2. Disconnect the freezer fan wire harness.
3. Remove the two 1/4-in. hex-head screws from
the top of the evaporator cover.
4. Lift the bottom of the cover to release 3 bottom
tabs, then pull cover out from the back wall.
,
Freezer Fan
Disconnect
Tabs