GEAppliances CFE28TSH Technical Service Manual page 63

The fresh food door and freezer drawer have
magnetic gaskets that create a positive seal to the
front of the steel cabinet. The magnetic gaskets are
secured to the doors/drawer by a barbed edge that
locks into a retainer channel.
1. Starting at any corner, pull the old gasket out of
the retaining channel.
2. Soak the new gasket in warm water to make it
pliable.
3. Push the barbed edge of the gasket into the
retainer channel.
• Depending on the model, 5 or 7 Pin-Point LEDs
are located in the fresh food compartment.
One or 2 Pin-Point LEDS are located in the
bottom of the left freezer door. Multiple LEDs are
connected in a series circuit.
• When the freezer door is opened, the lights in
the bottom of the left fresh food door come on
to illuminate the freezer baskets. If the left fresh
food door is opened while the freezer door is
open and the right fresh food door is opened,
the freezer lights will stay on.
• When the fresh food or freezer door is open,
the LED lighting should come on and stay at full
power for 8 minutes. After 8 minutes, the lights
should start to lower their intensity in a smooth
transition over the next three minutes to 75% of
closed and reopened, the timer will restart.
•
that LED will not be lit while the others will be
dim.
• When one LED fails completely, none of the LEDs
will light.
• With a voltmeter, 5 VDC – 20 VDC can be read
across the terminals of the completely failed LED
assembly.
• Each LED has a 2-pin connector for easy
replacement.
– 63 –
(Continued next page)