GEAppliances CFE28TSH Technical Service Manual page 44

Remove the four 1/4" screws from the UI Bracket.
tabs where the brewer attaches to the dispenser,
starting with the left. When reassembling, ensure
both tabs are engaged.
Pull the UI forward and lean the top forward, then
disconnect the two connectors from the board.
Remove the 1/4" mounting screw on the Bracket
and Motor Assembly, then pull it forward.
Squeeze then slide the spring clamp up from the
the harness connector.
When reinstalling the spring clamp make sure
the tabs are not pointing forwardard as they will
interfere with proper reinstallation of the UI housing.
Only available as a complete assembly
The hot water outlet tube connects at the top right
of the recess with a black barbed quick connector
and a spring clamp.
– 44 –