Articulating Door Mullion - GEAppliances CFE28TSH Technical Service Manual

The articulating door mullion is attached to the
left side door, and provides a movable center
mullion that maximizes access to the fresh food
compartment. With both refrigerator doors closed
or only the right side door opened, the mullion stays
in position. When the left side door is opened, the
spring-loaded mullion is activated to fold against
the handle side of the door liner.
The pin on top of the mullion and the track, located
at the top center front of the refrigerator, ensures
proper mullion bar alignment upon closure of the
left side door.
The articulating door mullion consists of the mullion
and heater. The articulating door mullion is supplied
as an assembly.
The heater operates on 12 VDC with the doors
closed. Operation is based on room temperature
and humidity.
The resistance value of the heater is approximately
24.7 W. Check for the correct voltage and resistance
on the door board at J3 pin 4 to J3 pin 20.
1. Open the left door and move the articulating
door mullion to the door-closed position.
2. Remove the two T-10 Torx screws from the wire
harness cover.
3. Pull out and disconnect the wire harness.
– 101 –
Disconnect
(Continued next page)