GEAppliances CFE28TSH Technical Service Manual page 103

To access the main control board, it is necessary to
remove the two 1/4 in. hex head screws then slide
the cover down from the two tabs.
Tab
The main control board is attached to the recess
with two tabs, one on each side. Some models may
have two screws or two compression pins.
The board is connected to the refrigerator with
eleven wire harnesses. To remove the board, it is
necessary to disconnect the wire harnesses. Then
remove the 1/4" screw at the bottom left, the plastic
pin at the top left. Slide the board to the left to
release from the right tabs.
Plastic Pin
1/4" Screw
The door control board controls all AC and DC
functions of the left side fresh food door.
The door control board is attached to the bottom
Tab
of the door board cover. The door board cover is
attached to the top of the left side fresh food door
with three screws and two tabs located inside the
door board cavity.
1. Remove the three T-15 Torx screws that attach
the door board cover to the top of the left side
fresh food door.
2. Lift the back of the cover and disconnect all of
the wire harnesses connectors from the door
Tab
board.
Tab
3.
door board to the cover.
– 103 –
Door Board Cover