GEAppliances CFE28TSH Technical Service Manual page 89

Use Service Diagnostic Mode to enter service
diagnostics (see Service Diagnostic Mode). Use
diagnostic code to cycle icemaker in the door
and 01 00 to cycle icemaker in the freezer.
The service test will consist of a harvest cycle
The harvest cycle will be entered immediately,
regardless of mold temperature or feeler arm
position.
The mold heater will be turned on for a minimum of
20 seconds.
cycle will be initiated.
freeze cycle.
During the service diagnostic test, the feeler arm
position sensor and motor position sensor are tested
by the control board software. The motor and water
valves are energized and can be visually observed
for diagnostic purposes.
Under normal operating conditions, the icemaker
is capable of producing approximately 100 - 130
cubes (approximately 4.3 pounds of ice) in a 24
hour period. The rate of ice production depends
on freezer and ice box compartment temperature,
room temperature, number of door/drawer
openings, and other use conditions.
The icemaker is located inside the left side
refrigerator door.
1. Open the ice box door and remove the ice
bucket.
2. Remove the 5/16 in. hex head screw from the
wire harness cover.
Cover
3. Lift the bottom of the wire harness cover, then
remove the cover.
4. Disconnect the icemaker wire harnesses.
Disconnect
5. Remove the bottom center 5/16 in. hex head
screw that attaches the icemaker to the ice box.
6. Lift and remove the icemaker.
– 89 –
Lift
Disconnect
(Continued next page)