The Doors (Double Door Refrigerator Models Only); Reversing The Door Swing - GEAppliances Appliances Profile 20 Owner's Manual And Installation Instructions

Installation Instructions
REVERSING THE DOOR SWING
(Single Door Refrigerator Models only)
IMPORTANT NOTES
When reversing the door swing:
NOTE: Door swing is not reversible on stainless
steel models.
, Read the instructions all the way through before
starting.
, Parts are included in the door hinge kit.
, Handle parts carefully to avoid scratching paint.
, Set screws down by their related parts to avoid
using them in the wrong places.
, Provide a non-scratching work surface for
the doors.
IMPORTANT: Once you begin, do not move the
cabinet until door-swing reversal is completed.
These instructions are for changing the hinges
from the right side to the left side-if you ever want
to change the hinges back to the right side, follow
these same instructions and reverse all references
to left and right.
, Once door swing is finalized, ensure the logo
badge is properly aligned and permanently
secured to the door by removing the adhesive
cover on the back side. NOTE: A replacement
logo badge is included in the hinge kit.
Unplug the refrigerator from its electrical outlet.
Empty all door shelves, including the dairy
compartment.
TOOLS YOU WILL NEED
Adjustable Wrench
5/16" Socket
Ratchet/Driver
Hasking Tape
@
Thin-blade Screwdriver
Phillips Screwdriver
Torx T-20 Driver
24
[] REMOVE THE
REFRIGERATOR DOOR
r_ Tape the door shut with masking tape.
o@
r_ Remove the hinge cover on top of the
refrigerator door by carefully prying it up with a
putty knife, if necessary.
[] Using a 5/16" socket ratchet/driver, remove
the bolts securing the top hinge to the cabinet.
Then lift the hinge straight up to free the hinge
pin from the socket in the top of the door.
r_ carefully remove the door thimble from inside
the socket. This will be used again when
reinstalling the door on the other side.
Q
Hinge Cover
Top Hinge
Door Thimble
Remove the tape and tilt the door away from
the cabinet. Lift the door off the center hinge
pin. Ensure that the plastic hinge pin thimble
remains on the hinge pin or inside door hinge
pin hole located in the bottom of the door.
FF1 Set the door on a non-scratching surface with
the inside up.