Freezer And Fresh Food Drain Trap Tubes - GEAppliances CFE28TSH Technical Service Manual

The freezer and fresh food drain trap tubes
connected inside the cabinet and exit through a
common drain outlet tube.
A check valve is located between each drain outlet
tube and each drain trap tube.
Each drain trap tube can be removed by pulling it
evaporator drain tube.
Drain Outlet Tube
Drain Tube
An improperly assembled drain trap tube
and check valve can result in a distorted check valve
trough. To ensure the check valve functions properly,
the check valve must be installed onto the drain trap
outlet tube at the bottom of the cabinet.
The condenser fan is located in the machine
compartment between the 3-way valve and the
condenser.
The condenser fan will operate at 1000 RPM –2100
RPM with RPM feedback to the control.
1. Remove the machine compartment cover (see
2. Remove the 1/4 in. hex head screw that
3. Carefully reposition the 3-way valve and drier
4. Disconnect the wire harness attached to the
5. Disconnect the fan and valve wire harness from
evaporator drain
evaporator drain
– 77 –
the Machine Compartment Cover section).
attaches the 3-way valve bracket and rubber
grommet to the refrigerator.
to gain better access to the condenser fan and
valve wire harnesses.
back of the 3-way valve coil.
the cabinet.
1/4" Screw
Rubber Grommet (behind bracket)
Disconnect
(Continued next page)